MFC Anhydrit 020 (025, 030) is a coating mixture based on Anhydrite. It is suitable for poured levelling (base) floor layers - under the flooring in civic and residential buildings.
MFC Anhydrit 020 is fresh self-levelling coating mixture based on calcium sulphate (anhydrite), filling, additives and water. While curing the crystal structure is being created in coating; relatively big and compact crystals connect each other thus creating minimal quantity of hollow space only Thanks to such structure the anhydrite coating reaches high strength.
Anhydrite coating is used for poured levelling (grounding) floor layers aspecially at residential, civic and indiustrial buildings with operational stress up to 7,5 kN.m-2. At higher operational stresses is necessary to determine higher coat thickness, higher grade of strength and/or combination of both. Anhydrite coating is also very acceptable for floor heating systems – coating composition is homogenous in whole thickness with no need of further compaction (good heat conductivity), there is no need to dilate individual heating circuits. Anhydrite coating floors are installed with levelling of ± 2 mm.m-1 and they do not require other levelling screed fore installation of final surface layer. The whole range of flooring maeterial can be used, while observing the flooring installation regulations issued by flooring manufacturer.
We deliver with Transmix/Bremat most up-to-date equipment
TransMix/Bremat mixing and mobile set is mainly for production of liquid coating at the construction site. It i equipped with material storage tanks, mixing set and helical pump. The fresh coatin is transported via mentioned equipment directly to intended location.
Main advantages:
- fully automated production with exact batch processing takes care of steady coating quality
- TransMix stays at the site for the time really needed to install coating
- coating production and transportation is continuous, there is neither worker nor machine idle time
- the quantity needed for particular surface is produced only - minimalization of additional cost
- immediate consumption supervision on the spot
- minimal requirements to the construction site equipment
We cover almost whole Czech and Slovak Republic...
We cover map with four points of alert: Tišnov u Brna, Praha - Modletice, Hradec Králové a Senec u Bratislavy!
Quantity is no challenge to us...
At the meantime we already have seven fully equipped sets on hand, with daily output reaching more than 210 m?!
